Check if you’ve received all 2 boxes without any damages and all the elements are inside. If so, you’re good to go! Remember to assemble on a blanket, carpet or to use our cardboard. Got a friend around? For some steps, you might need help of another person.

Insert 2 dowels into each smaller front element. Then, place the steel nut into the larger front element. Connect the parts together as shown in the picture.

Flip the element and insert the following screws: 2 x 2 Confirmat screws on the sides (see the picture), tighten them with the Allen key; 2 x M6x33 pin on the sides, in the upper holes, tighten with your hand; 2x Pin for Inner Beams in the middle, tighten with your hand.

Take the 2 parts of the headboard and insert the following elements in this order: 4 x ECM ⌀25 connectors (the arrow symbol must be directed toward the hole as pictured), 2 x ⌀7x56 pins, both on one side, 4 dowels.Take the 2 parts of the headboard and insert the following elements in this order: 4 x ECM ⌀25 connectors (the arrow symbol must be directed toward the hole as pictured),2 x ⌀7x56 pins, both on one side, 4 dowels. Join the parts together and securely screw them using the Allen key (refer to the picture).

Take the 2 side beams and insert the following elements in this order:3 x ECM ⌀25 pins into the right holes on the side of each beam, the arrow symbol must be directed toward the hole as pictured,2x Pin for Inner Beams in the middle, tighten with your hand;1 dowel on the outer edge.

Attach the legs to the length beam using 2 x M8x35 screws and the Allen key. Repeat the action with the width beam.

Connect the length and width beam as pictured, using 2x M8x35 screws and Screw Nut.

Use books/boxes/etc. to support the side beams.Connect the side beams and the width beam. The pins must meed the holes in the width beam.Use 4x little screws M6 to connect the parts together as pictured. Tighten with a screwdriver.

For this step you’ll need help of another person.Place the headboard upside down and insert 4 steel nuts into the rear holes. Tighten the M6x33 pins firmly into the corresponding front holes.Now, insert 2 x Pin for Inner Beams into the headboard. Connect the headboard and the length beam - the pins must meed the holes in the beam.

With assistance to hold the headboard steady, connect the headboard with the side and length beams. Firstly screw the side beams with the Allen key, then use the screwdriver and 2x little screws M6 to tightly screw the length beam.

With assistance to hold the headboard steady, connect the front element with the side and length beams. Firstly screw the side beams with the Allen key, then use the screwdriver and 2x little screws M6 to tightly screw the length beam.

Securely attach the 4 mounting sheets to the frame using the Allen key and 4 x M6x12 screws for each iron.

Place the slats and mattress inside the frame.