Check if you've received all 3 boxes without any damages. If so, you’re good to go! Remember to assemble on a blanket, carpet or to use our cardboard.

Slide the first leg over the M1 part in a way shown in the picture. Screw it tightly using a screw and the Allen key. Tighten up the two remaining screws. Mount the remaining legs.

Screw in the middle leg.

During the next steps use the hammer (to place the walls in correct position) and the screwdriver (to adjust the screws if necessary). To avoid damaging the furniture, please remember to secure the hammer with a cloth.

Prepare the walls. Place them in a way that the screws hide in the connectors’ holes. Pull them towards the front until they’re even.

Place the M2 part in a way that screws hides in connectors' holes. Pull it until it's even with the walls.

Stick the dowels into the bottom part. Then mount the M3 part at an angle starting from the bottom. Push the pins as presented in the detail and put the M3 part in place.

Place the sliding door in the rear rail.

Place the ornamented glass door in the front rail.

Slide in the M8 part.

To avoid damage of furniture, always lift it above the floor while moving it.