Check if you've received the box without any damages. If so, you’re good to go! Remember to always assemble furniture on a blanket, carpet or on the cardboard you got from us.

Attach the side panels to the headboard: slide the side panel fittings onto the bolts protruding from the headboard, then tighten with the Allen key.

Attach the 2 legs to the footboard.

Attach the footboard: slide the footboard bolts into the fittings mounted on the side panels, then tighten with the Allen key.

Install the center support beam: slide the fittings at both ends of the beam onto the bolts protruding from the headboard and footboard, then tighten with the Allen key.

Attach the 4 angle brackets: place a washer in each hole and fasten using M8x20 bolts with the Allen key.

Place the slatted frame. The bed is ready to use. If you have a bed with a lifting mechanism, please continue to the next step of the instructions.

Insert the 2 support boards.

Assemble the slatted frame: check that the box is undamaged and that all elements are included.

Connect the corner connectors with the rails (side rails, end rail, and front rail). Fasten them with the small 4.8x15 screws using a Phillips screwdriver.

Attach the double slat caps to the main support rail.

Fix the main support rail to the previously assembled frame on both sides. Use M8x20 bolts and the Allen key.

Attach the gas struts to the bed hinges. On each protruding rod, place one washer, then the gas strut, then the second washer, and secure everything with a nut, as shown in the animation.

Attach the hinges to the frame. Use M8x20 bolts and the Allen key.

Attach the assembled frame to the the bed frame. Use the M8x20 bolts and the Allen key.

Place the 2 mattress stoppers on the back edge of the frame, as shown in the animation.

Insert the slats into the frame: place each slat into the double slat cap, then fit a single slat cap onto the other end of the slat and attach it to the frame. Repeat this step for each slat.

Place the mattress on top.